Description
An anti-slip floor paint based on an epoxy ester formulation that dries to a tough durable finish.
Has good resistance to water, oils, mild acids and alkalis.
Available in 3 colours

Recommended Use
Ideal for use on concrete, timber and steel floors.
The use of organic powder to produce the anti-slip properties has eliminated the risk of sparking from metal wheels and tools, unlike some floor coatings that contain sand or grit. This anti-spark feature provides extra safety, for example in factories or chemical plants, where sparks are hazardous.
Recommended Application:
Conventional spray, Roller or Brush
Coverage - approx 65m2 per 5 litre tin per coat.
Normally 2 coats required.
Drying Time @ 20ºC:
Surface dry - 1½ hours., Hard dry - 5 hours., Overcoat after 16 hours.
Drying times will be extended at low temperatures.
Do not apply when ambient temperature falls below 5ºC or relative humidity exceeds 90%
Technical Specification:
Finish: Non-slip sheen
Flash Point: 38ºC
Dry Film Thickness: 15 - 35 µ
Wet Film Thickness: 40 - 100 µ
Practical Covering Capacity:
Approximately 13 Sq M per litre @ 25 µ DFT
Slip Resistance:
Dry: 52 - Low slip potential
Wet: 44 - Low slip potential
(Results obtained using BS7976 Slider 96 Pendulum Test)
Application Notes
All surfaces should be clean, dry and free from grease, rust, mill scale, etc.
Apply 1 or 2 coats, preferably by brush or roller.
This paint should not be applied to newly laid concrete unless it has thoroughly dried out.
Allow 1 month per inch thickness of concrete laid for curing prior to painting.
The initial coat may be thinned to seal the substrate.
Loose or dusty concrete should be abraded by mechanical methods before painting.
Heavy traffic should be avoided on newly painted surfaces for a period of 72 hours after painting.
For further information contact our Technical Service Department.
Availability:
5 litre tins only
